mdrodge Posted March 18, 2021 Share Posted March 18, 2021 When in dos and flashing i get "Warning! IO Base address high. Currently not supported." I was getting that originally aswell but each section finished with "success" Is that okay? Quote Link to comment
mdrodge Posted March 18, 2021 Share Posted March 18, 2021 (edited) And that was the last time it was seen alive. 20 minutes trying to get the pc to boot and i get this Oh wait... It's still detected in dos. Wtf. Edited March 18, 2021 by mdrodge Quote Link to comment
mdrodge Posted March 18, 2021 Share Posted March 18, 2021 Then dos started to hang on 2.bat or 4-11.bat. I guess it died. This makes no sense. Quote Link to comment
FingerlessGloves Posted March 18, 2021 Share Posted March 18, 2021 Have you got the card in the right PCI slot? Usually needs to be the one closest to the CPU Quote Link to comment
Peddarson Posted March 19, 2021 Share Posted March 19, 2021 Thank you for the guide. The flashing process went buttery smooth on an a21 model. Quote Link to comment
kerby Posted September 28, 2021 Share Posted September 28, 2021 (edited) Hi! After successfully flashing the A21 controller, I get a message ("mpt2sas_cm0 overriding nvdata eedptagmode setting") when debian 10 is loading. My mdadm raid-1 does not work with this. What can be done? Edited September 28, 2021 by kerby Quote Link to comment
FingerlessGloves Posted September 29, 2021 Share Posted September 29, 2021 (edited) On 9/28/2021 at 3:36 PM, kerby said: Hi! After successfully flashing the A21 controller, I get a message ("mpt2sas_cm0 overriding nvdata eedptagmode setting") when debian 10 is loading. My mdadm raid-1 does not work with this. What can be done? I'm not sure, do your disks show at all? Edited October 25, 2021 by Jonny Quote Link to comment
Pilaarbijter Posted October 21, 2021 Share Posted October 21, 2021 On 9/28/2021 at 4:36 PM, kerby said: Hi! After successfully flashing the A21 controller, I get a message ("mpt2sas_cm0 overriding nvdata eedptagmode setting") when debian 10 is loading. My mdadm raid-1 does not work with this. What can be done? Was this resolved? Quote Link to comment
C30nn4 Posted November 3, 2022 Share Posted November 3, 2022 (edited) Hi (literally created an account to ask about this) I followed all the instructions and managed to get as far as completing the EFI stage but once I completed that and rebooted to switch back to BIOS to complete the process it has just been hanging on the blinking underscore screen and not doing much if anything, on either of the D2607s I ran through (they're 21s and I used the 21 version, and second time through I wiped it twice before running the rest. No difference). What's gone wrong here? I can't imagine it's hardware related when both those devices aren't booting Thanks Edited November 3, 2022 by C30nn4 Quote Link to comment
Erik Weisbrod Posted October 3, 2023 Share Posted October 3, 2023 Thank you very much for the great manual, it went buttery smooth! Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.