Trim Not Running Properly

[Stix]

Hey all,

 

I am running unRAID v6.2.1 and recently had the main cache drive of my 2 cache drive raid 1 setup fail. I purchased a new cache drive, attached it, and ran a balance. I thought everything was running fine until I went to do a manual trim and noticed it is consistently only trimming 48 kilobytes. Both drives are Samsung 850 EVO 250GB SSD drives.

 

Is there any way I can get trim running properly without backing up the data, formatting the drives, and re-doing my docker image?

 

Here is my drive and raid 1 info:

btrfs filesystem show:

Total devices 2 FS bytes used 91.01GiB

devid    1 size 232.89GiB used 232.88GiB path /dev/sdh1

devid    2 size 232.89GiB used 232.88GiB path /dev/sdi1

 

btrfs filesystem df:

Data, RAID1: total=230.85GiB, used=90.32GiB

System, RAID1: total=32.00MiB, used=64.00KiB

Metadata, RAID1: total=2.00GiB, used=702.25MiB

GlobalReserve, single: total=240.00MiB, used=0.00B

 

Edit: Ended up copying all data to a data drive via midnight commander, formatting the cache drives to riser, then setting them up again as btfrs. Fun times!