Parity drive failed, replacement failed?


Recommended Posts

So I had a 'failed' parity drive for some time and since I haven't found the time to test it, I bought a new drive the other day. Now both seem to be displaying the same symptoms.

 

Both drives are WD30EFRX (3TB WD Red). I've already replaced the SATA cable, but may do so again. No other drives seem to be experiencing any issues. Not entirely sure what is going on.

 

New drive pre-cleared without issue, as far as I can tell. It was only after I added it to the array did it start to 'fail.' I'm not convinced this is drive-related.

 

Attachments:

  • HostReset - My most successful attempt at a SMART report via unRAID, got to 90% then 'host reset' ... :(
  • Syslog from today

 

I'll try and get a full SMART report for both drives but this doesn't seem to work via the web interface either...

HostReset.JPG.e5ab7a1e15586d5f6de759df4bd8e2e9.JPG

syslog.txt

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.