sirkuz

Nevermind, had installed on a custom network and those ignore custom port settings I don't seem to be able to change the webui port from 3000. Whatever I set it to it just goes back to 3000. Tried a few times and pulling down fresh. Anyone else have this issue? I already have grafana on 3000.

and yep... cycling the docker service did the trick

dug a bit deeper on it and seems like its unraid networking related to the vlan bridge I have on an interface not routing properly. Disregard please (sorry I deleted the question before I saw a response).

Ran into this today as well under 6.10.0-rc2

Yes, both exist on cache pool which is a pair mirrored 1TB nvme drives.

I am doing some further testing while doing a parity rebuild in safe mode... I have also discovered that simply enabling the docker service results in a performance hit, even with all containers stopped. In my case I estimate it to be around 30MB/s speed. As soon as I stop the docker service I get those 30MB/s back. This could take a lot of time to try and track down if I have both plugins and docker service causing issues with parity speeds. 🤪

Right, trying to track down which might be the culprit next. Right now trying to get my drive updates done as quickly as possible then will have some time to start removing plugins and testing each time.

Did some more testing today on my faster drive machine. I doubled my parity speed by enabling safe mode and gained another 50% speed increase when booting 6.7.2 6.10.0-rc2 safe mode ~100MB/s 6.7.2 safe mode ~150MB/s sometimes seeing as high as 170-180MB/s Restoring 6.10.0-rc2 NON safe mode, containers/vms disabled 45-50MB/s reboot 6.10.0-rc2 safe mode ~100MB/s again

It is unfortunate. At this point it might be worth my time to actually downgrade my fast server that I am upgrading just so I can complete the drive replacements in a more timely manner. 3 days for each is killer when doing 10 drives. I'll send in some feedback directly from my systems for them as well.

Thanks, got that system downgraded. Very similar hardware other than the drives themselves. Same gen cpu ram and same exact controller model. Drives are slower. Downgrading from 6.10.0-rc2 to 6.7.2 my parity check read speed almost double. Seeing as high as 110MB/s on that array compared to the previous 50-60 range.

Sorry, but I am coming up empty trying to find a link to download 6.7.2. Do you happen to have a link to older versions like this? I have a secondary server with the same controller I might try it on first to see if it makes a difference. That system has slower drives already but similar hardware and numbers of drives. Thanks in advance!

I'll give it a go after current sync is done in a couple days to see what the speeds look like. Appreciate the help!

Not sure I can downgrade without breaking a bunch of stuff. Specifically running my containers with ipvlan rather than macvlan. Might be better off rolling a new trial USB and testing that way if I can prevent ruining my current configuration

With it being so slow I am currently living dangerously and doing a two drive upgrade since I have dual parity. Currently at ~55MB/s each around the 46% mark.

If I recall correctly I'll start out around 60MB/s or slightly above before settling in around 50-55MB/s.